CREE Chip 220V 60Hz 30W Explosion Proof Led Flood Light
Explosion proof led flood light 30W 220V 60Hz emergency time 60
minute IP66 IK10
Lighting solutions for Ex Hazardous Area
With decades of experience as a global supplier to the marine and
oil & gas industry, our main focus will always be quality, safety
and service. For hazardous areas, it is very important that the
product is designed for use in the designated area, and that
certifications and specifications are according to the
requirements. LCD EX lighting solutions have been developed through
years of experience. Our experienced staff can give you advice on
explosion proof lighting for the offshore industry.
Item List
| Rated power(W) | 20w | 30w | 40w | 50w |
| Rated voltage(V) | AC220v /230v /240v |
| Protection grade | IP66 |
| Corrosion-proof grade | WF1, WF2 |
| Charging time(h) | 24 |
| Inlet thread | G3/4 |
| Emergency time (min) | 60/90 |
| Emergency light start time | 0.3S |
| Cable outer dia.(mm) | Φ10~Φ14 |
| Ex-mark | Ex d II C T6 Gb
Ex tD A21 IP66 T80 |
*: Required when ordering.
Ex areas can be known by different names such as “Hazardous
Locations”, “Hazardous Areas” “Explosive Atmospheres”, and the like
and relate to areas where flammable liquids, vapors, gases or
combustible dusts are likely to occur in quantities sufficient to
cause a fire or explosion.
Products designed and developed to be installed and used in
hazardous areas must be certified in accordance with project and
regional requirements. The standards for hazardous areas are not
the same for all regions.
IECEx - International Electromechanical Commission System for
certification to standards relating to equipment for use in
explosive atmospheres.
Atex – Regional European ATEX directives for equipment (94/9/EC) and
worker protection (1999/92/EC) in potentially explosive atmospheres
become mandatory for European installation from 1st July 2003.
LCD-HLBD55-C/D Series Explosion-proof LED Lamp (IIC, tD)
Application
1. Zone 1 and Zone 2, Group IIA, IIB, IIC explosive gas
environment, and/or Zone 21, Zone 22 combustible dust environment;
2. Temperature class: T1~T6;
3. Indoor and outdoor (IP66);
4. Used in chemical industry, oil refining, petroleum exploitation,
offshore oil platform,oil tanker, military and other dangerous
places for lighting and emergency lighting during power failure.
Diagram of cold and hot air moving in and out
Distribution Curve
LCD-HLBD55-C Outline and Installation Dimension
LCD-HLBD55-D Outline and Installation Dimension
